#cr6 — Public Fediverse posts

@synack @3dprinting the presets in #prusa were quite good for my #creality #CR6-SE. But after a year, I have greatly improved it by tuning it every time after a print.

You can also find profiles for your printer on #reddit. I have taken speed profiles from there and tuned them for myself.

This is my take on the #3dprinting #challange of printing the print-in-place chainmail.

I used a creamy #PLA, which is softer and more pliable, which resulted in smooth and softer movements. A 0.4mm nozzle was used with 0.16mm layer height. The entire #print took about 3 hours on my #creality #CR6-SE

#3dprinting #3dprint #3dprinter #3dprintingchallenge

@3dprinting

This is my take on the #3dprinting #challange of printing the print-in-place chainmail.

I used a creamy #PLA, which is softer and more pliable, which resulted in smooth and softer movements. A 0.4mm nozzle was used with 0.16mm layer height. The entire #print took about 3 hours on my #creality #CR6-SE

#3dprinting #3dprint #3dprinter #3dprintingchallenge

@3dprinting

This is my take on the #3dprinting #challange of printing the print-in-place chainmail.

I used a creamy #PLA, which is softer and more pliable, which resulted in smooth and softer movements. A 0.4mm nozzle was used with 0.16mm layer height. The entire #print took about 3 hours on my #creality #CR6-SE

#3dprinting #3dprint #3dprinter #3dprintingchallenge

@3dprinting