#printbed — Public Fediverse posts

There's no way... after all the repairs, I still cannot print anything larger than a few centimeters with my #creality #ender5 #3Dprinter... part of the #brim (and of the first layer as well) refuses to #stick to the #printbed. I can level the print bed and have the four angles at the right distance from the #nozzle (in fact the first extrusion sticks perfectly) but then the center is too low. I can place a little sheet of paper under the mat at the center of the print bed and then the center is ok, but some places around are lower... It's very #frustrating, and I really don't know what to do at this point...

There's no way... after all the repairs, I still cannot print anything larger than a few centimeters with my #creality #ender5 #3Dprinter... part of the #brim (and of the first layer as well) refuses to #stick to the #printbed. I can level the print bed and have the four angles at the right distance from the #nozzle (in fact the first extrusion sticks perfectly) but then the center is too low. I can place a little sheet of paper under the mat at the center of the print bed and then the center is ok, but some places around are lower... It's very #frustrating, and I really don't know what to do at this point...

There's no way... after all the repairs, I still cannot print anything larger than a few centimeters with my #creality #ender5 #3Dprinter... part of the #brim (and of the first layer as well) refuses to #stick to the #printbed. I can level the print bed and have the four angles at the right distance from the #nozzle (in fact the first extrusion sticks perfectly) but then the center is too low. I can place a little sheet of paper under the mat at the center of the print bed and then the center is ok, but some places around are lower... It's very #frustrating, and I really don't know what to do at this point...

There's no way... after all the repairs, I still cannot print anything larger than a few centimeters with my #creality #ender5 #3Dprinter... part of the #brim (and of the first layer as well) refuses to #stick to the #printbed. I can level the print bed and have the four angles at the right distance from the #nozzle (in fact the first extrusion sticks perfectly) but then the center is too low. I can place a little sheet of paper under the mat at the center of the print bed and then the center is ok, but some places around are lower... It's very #frustrating, and I really don't know what to do at this point...

There's no way... after all the repairs, I still cannot print anything larger than a few centimeters with my #creality #ender5 #3Dprinter... part of the #brim (and of the first layer as well) refuses to #stick to the #printbed. I can level the print bed and have the four angles at the right distance from the #nozzle (in fact the first extrusion sticks perfectly) but then the center is too low. I can place a little sheet of paper under the mat at the center of the print bed and then the center is ok, but some places around are lower... It's very #frustrating, and I really don't know what to do at this point...