#zwavejs — Public Fediverse posts

Ok, this is really trippy:

My failed #HomeAssistant experiment with #ZWaveJSUI has produced the following surprise:

#ZWaveJS now has the entire ZWaveJSUI user-experience, including the logo and the developer's support links.

ZWJSUI has been completely deleted from HAOS. And yet...

I need to burn it all down at start over.

I've determined I need to once again split off my #ZWaveJS install to its own Raspberry Pi from the #HAOS Raspberry Pi so I can put #HomeAssistant into the Locked Closet while keeping the ZWave stick in range of all the ZWave stuff that doesn't play well with repeaters and now I have a vague sense of dread. 😩

Upgrade of my #zwave controller from 700 to 800 series was uneventful. #homeassistant +#ZWaveJS was just a matter of backing up and then restoring the NVM.

Well, I did have to go add USB ACM to my #linux kernel but that's my own fault for not using modules. 😁

Picked up an ATRIM #zwave 800 stick to try and replace my SIL 700 series one. It shipped with 7.17.2 firmware and refuses to take an upgrade in #ZWaveJS , throwing an update error after pushing the 4204D.gbl firmware file.

Any #homeassistant peeps have an idea?

Obviously, the 700 series stick upgrades just fine (running 7.21.2 on it now).

TubesZW??? Almost, but not quite 😎

Kits are now available with everything you need for a PoE Z-Wave adaptor, everything but the radio that is. Due to the differing global frequencies and the z-wave certification process I have no desire to make a custom radio module. Instead the kits work with most Raspberry Pi GPIO Z-Wave modules. (Zooz 800 LR and Razzberry Pro 7 Tested)

https://tubeszb.com/product/z-wave-poe-kit/

#zwave #ZWaveJS #homeassistant

si quelqu'un a déjà eu le prob avec #ZWaveJS UI et #domoticz je galère

https://easydomoticz.com/forum/viewtopic.php?p=116630&sid=998e2c23e68d9291e9debbd642dbdd7e#p116630

@sstranger @andy_warb @zigbee @homeassistant

I haven't had speed issues with my sensors. I moved my zigbee from a huzbsb-1 to a conbee II so that I could run #zigbee2mqtt on a different HC2 than the one I run #zwavejs on. I run HA on a 3rd since I have several odroids I'm using as #moosefs chunkservers and don't need to jam them all into one machine.

A stronger mesh is always a good thing though.

IoT efforts going well these last days. Two smart thermostats, power meter, converted my #vera to #zwavejs & #zigbee2mqtt. Discovered via the @homeassistant energy panel the supercool AI on the edge project for reading gas, water and electricity meters. https://github.com/jomjol/AI-on-the-edge-device
Challenge accepted. First ESP32 already flashed, now the mechanical part of fixing it on my outside gas meter...