#timingbelt — Public Fediverse posts on home.social

Greg Saunier @bear_lab · 2024-02-12 · 14:10 UTC

1/2
Why is the belt moving up and down?

This is generally due to 4 things:
- Angular misalignment of the pulleys/idlers
- Parallel misalignment of the pulleys/idlers
- Belt quality, wear and type
- Pulleys/idlers quality and wear

It is also good to know that long belts have the teeth cut at a very small angle which could also increase this phenomena.

#3dprinting #machinedesign #belt #timingbelt #corexy @3dprinting

#3dprinting #machinedesign #belt #timingbelt #corexy

EllisGL @[email protected] · 2023-01-07 · 13:45 UTC

I wonder if a #SilentSync #belt and #sprocket setup would improve the #print quality of a #3DPrinter. 16mm belts would probably reduce #ghosting / #ringing, but would the offset herringbone tooth pattern reduce some, if not all of the XY wavey artifacts? Maybe the #VoronDesign, #HevORT, or #VzBoT folks would like to investigate?
https://www.silentsync.com/silentsync-sprockets/yellow-timing-pulley-sprockets
#3DPrinting #3DPrint #kinematics #hardware #belts #TimingBelt #sprockets #Voron

#silentsync #belt #sprocket #print #3dprinter #ghosting

EllisGL @[email protected] · 2023-01-02 · 15:46 UTC

I wonder if a #SilentSync #belt and #sprocket setup would improve the #print quality of a #3DPrinter. 16mm belts would probably reduce #ghosting / #ringing, but would the offset herringbone tooth pattern reduce some, if not all of the XY wavey artifacts? Maybe the #VoronDesign or #HevORT folks would like to investigate?