home.social

#sdrangel — Public Fediverse posts

Live and recent posts from across the Fediverse tagged #sdrangel, aggregated by home.social.

  1. I've just received aircraft all the way into France and Germany from high up north in the Netherlands.

    This setup shows the reception of in receiving about 140 frames per second using an rsp v1.

    I am about to set on holiday and might write a short blog post on the antenna stack.

  2. Bought a cheap + together with a small antenna for really impressed by the result so far. This is still inside the house.

    The setup also uses an using the Android app.

  3. @electragician be warned: rabbit hole ahead. Have fun.

    You might want to have a look at #SDRPlusPlus. I find it easier to use and more pleasant to look at than #gqrx.

    Also have a look ad #SDRAngel. That has some handing tools inbuilt to decode packet/aprs, adsb and many other digital signals.

  4. Any body with any experience with SDRAngel on Linux? I want to decode DMR/DStar/ect but can't find the DSD (Digital Speech Decoder) in any menu. Is there something special I need to do or do I need something specific to do it?
    I am using a RTL-SDR v3, and I can get other things to decode like APRS. I just can't figure out how or where the DSD is.

    #SDRAngel #SDR #Linux #DMR #Dstar #RTLSDR #APRS #Ham #Radio #decode

  5. Any #HamRadio, #telcom or other RF-interested folks want to take a guess as to what this signal might be? I can't figure it out.

    Starts at 418.360MHz and is about 13.5MHz wide (ends around 431.880MHz), with a soft peak around 428 where it's about 11dB above the noise floor using an indoor 24" whip.

    It's too low for LTE Band 31/72/73 or the 450MHz stuff. Super clean edges.

    FCC freq DB just says "CDMA 5,450 UPLINK" from 410-446.5 with no other explanation.

    #radio #SDRangel #SDR #Linux

  6. Started the morning playing with #sdrangel sending SMS and voice using #m17_project protocol. Was using HackRF and PlutoSDR hardware. Should of made screenshots. Perhaps later. After some errands finally got some time behind a soldering iron to finish soldering one of my Module 17 boards. Finished SMD work, still have a couple through hole components, and need to flash #openrtx firmware to device. Been a fun #hamradio hardware and software day. #sdr