#ratos — Public Fediverse posts
Live and recent posts from across the Fediverse tagged #ratos, aggregated by home.social.
-
#Meningite transmitida por #caramujo: em nova etapa, IOC/ #Fiocruz detecta #ratos infectados https://portal.fiocruz.br/noticia/2024/09/meningite-transmitida-por-caramujo-em-nova-etapa-ioc-fiocruz-detecta-ratos
Como segunda etapa da investigação epidemiológica para esclarecer óbito ocorrido em abril, por meningite eosinofílica, em Nova Iguaçu, na Baixada Fluminense, pesquisadores do Instituto Oswaldo Cruz (IOC/Fiocruz) voltaram à localidade. Dessa vez, para coletar e analisar roedores.
-
I got stuck, troubleshooting my #BTT #BigTreeTech #Octopus 1.1 mainboard, installed in newly assembled #RatRig #V-core #3Dprinter, running #RatOS aka #Klipper.
Both #nozzle (#extruder) #heater and #hotbed one do not warm up. Beyond all doubt (using external power sources and hairdryer) I confirmed that both thermistors, heaters and wiring are ok.
Under warranty, RatRig sent me replacement board, which I configured, flashed with updated firmware and got the same error.
I also tried to redirect the nozzle heater power to another pin (see in the config file at lib.tepewu.pl/f/8f1d29fe05d44c…) where I hooked up the multimeter. Nothing happened, when I set up nozzle temp to 50*C - after timeout I had the same error "extruder is not heating fast enough", thus klipper shutdown.
I cannot believe to have such a bad luck to got two boards with the same hardware fault (especially that steppers and hotbed probe work perfectly), so it is something I do not know - and I run out of ideas.
Please, somebody suggest something new. Hjalp.