#luthierie — Public Fediverse posts
Live and recent posts from across the Fediverse tagged #luthierie, aggregated by home.social.
-
Do you know what kind of lever goes on this vibrato tailpiece from a Japanese lawsuit SG from around 1970?
Can you show me a picture of one?
Bonus would be where I could get one. And a proper bridge. And a bridge pickup.
#guitar #question #luthierie
#Teisco #matsumoku -
Do you know what kind of lever goes on this vibrato tailpiece from a Japanese lawsuit SG from around 1970?
Can you show me a picture of one?
Bonus would be where I could get one. And a proper bridge. And a bridge pickup.
#guitar #question #luthierie
#Teisco #matsumoku -
Do you know what kind of lever goes on this vibrato tailpiece from a Japanese lawsuit SG from around 1970?
Can you show me a picture of one?
Bonus would be where I could get one. And a proper bridge. And a bridge pickup.
#guitar #question #luthierie
#Teisco #matsumoku -
Do you know what kind of lever goes on this vibrato tailpiece from a Japanese lawsuit SG from around 1970?
Can you show me a picture of one?
Bonus would be where I could get one. And a proper bridge. And a bridge pickup.
#guitar #question #luthierie
#Teisco #matsumoku -
Do you know what kind of lever goes on this vibrato tailpiece from a Japanese lawsuit SG from around 1970?
Can you show me a picture of one?
Bonus would be where I could get one. And a proper bridge. And a bridge pickup.
#guitar #question #luthierie
#Teisco #matsumoku -
Frotz!
I just got out the neck and was intimidated by how nice it is.
I think I"ll start with the neck from my plywood Dean Z. And some howto videos.
Do I need CA glue for the frets? Is normal okay, or do I need special thin stuff?
Where is the #1 place re-frets go wrong? (Guessing pulling the old frets.)
Can I get by with a plastic-faced mallet, or do I need a fancy tool that goes in my drill press?
-
Ordered fret wire (pre-cut, pre-curved) after comparing the cost of a full re-fret to a replacement Warmoth neck (about the same).
I have fret-pulling pliers. Hoping to get by using a Dremel for cutting them.