#kobra3 — Public Fediverse posts

3D Printing GCode Question:

Some how I set my print temp too low (by quite a bit) - Looking at the GCODE in a text editor I see these lines:

; EXECUTABLE_BLOCK_START
;TYPE:Custom
G9111 bedTemp=60 extruderTemp=200

Can I just change the temp here and save the file - or do I need to just make the changes on the printer just before it starts printing?
(Or reslice with the correct settings)

#gcode #3DPrinting #Kobra3 #Anycubic #3Dprinter #Question

What are #3Dprinters good for?

Printing toys for the grandkids of course.....

Made a #BenchyBoat 100% bigger then the original (or 200%)..... well, because the new printer can handle larger prints better then my older printers could. And because the grandkid thinks I'm a toy maker.

I guess, I am kind of.

#Anycubic #Kobra3 #PLA #3Dprinting #3dprinter #3dprint

I've kind of been saving this -
I made a trip up to #Columbus #Ohio this morning, because #Microcenter has the #Anycubic #Kobra3 #3Dprinter Before i went up I reversed it online, just so I knew I wouldn't be wasting a trip up.
And I also decided to look to see what they had on clearance.....
And I found 2 #Biqu #Bigtreetech 3d printers, one was $80.00 and one was $56.00

I didn't really need 3 brand new printers, but at that price it's hard to pass them up.