home.social

#crimping — Public Fediverse posts

Live and recent posts from across the Fediverse tagged #crimping, aggregated by home.social.

  1. For all of you that hate #crimping: The SN-2549 is the ultimate crimping tool for #jst. It crimps both parts in one go and it's as easy as it can get.

    10/10 would buy again.

    Give it a shot if you prefer soldering over crimping.

    #electronics

  2. All the wires have been crimped! This was very tedious and repetitive. But after the first few done, it went relatively smoothly.
    I only had to make two wires longer.
    Connector list:
    - ten six-pin JST
    - three two-pin JST
    - one four-pin JST
    - one ten-pin DuPont
    It looks very cramped, but it works!
    The steps are ordered columns first, like this:
    1 3 5 7 9
    2 4 6 8 10
    Else, I would have needed to make more wires longer.
    #diysynth #sequencer #electronics #crimping #cables

  3. Just made some cables with two resistors in-line, they should divide the voltage across the red wire and black wire (on the left) by half (on the right), while only pulling a small current (but enough for the buck converter lm2596s’ enable pin to draw from). This will save me from having to use a separate relay for toggling my 5V fans. Though I will need to tinker with #marlin firmware to invert the signals. #diy #electronics #3DPrinting #soldering #crimping #wire

  4. I crimped my first DuPont cable... the lengths of the wires don't match 100%, but it's good enough. It'll be used as extension to connect a servo with too short cable to my Arduino.
    #crimping #electronics #dupont #cable #Arduino #servo

  5. Confessions of a Crimpoholic - Hi, my name is Dan and I’m a crimpoholic.
    Honestly, I didn’t know I was a serial a... - hackaday.com/2022/04/04/confes #hackadaycolumns #toolhacks #crimping #rants #tools